Band Saw blade tracking

Home › Forums › Workshop Equipment › Bandsaws › Band Saw blade tracking

Viewing 1 post (of 1 total)
  • Author
    Posts
  • October 23, 2014 at 9:02 pm #12073
    Ritz
    Participant

    I have an older Delta band saw, I just cleaned lubed, put new tires on with a new skip tooth blade. No matter what I do I cannot correct the blades tendency to cut a curve inward. To cut a straight line free hand I have to move the tail of the work piece at least 20 degrees inboard toward the machine. Straight cut with a fence is impossible, even at super slow feed rate.

    HELP

    Thanks in advance

    Richard

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.